![]() |
#1
|
||||
|
||||
![]()
I have a Hardwood 1pc front end for my Chevy ii and I am going to install headlights with a factory bezel. I would like to make them adjustable. Are buckets (fiberglass, plastic etc.) readily available? Will I have to fabricate the parts? I would like for this to look good when I do it and still function. Any tips would be appreciated.
__________________
65 Deuce |
#2
|
||||
|
||||
![]()
Did you call Classic Industries or Hardwood and ask them? I remember somebody else asking this question a while back. Might of been on the other board before it crashed and everything was lost.
__________________
To make a friend, be one... |
#3
|
||||
|
||||
![]()
No. Didn't call. I'm trying to get it all figured out before I start.
__________________
65 Deuce |
#4
|
||||
|
||||
![]()
Think it came with a template and said that there was nothing to it.
__________________
To make a friend, be one... |
#5
|
|||
|
|||
![]()
S&W has almost anything you can think of and if they don't have it most times they can fab it for you. And they are a little cheaper than most others.
|
#6
|
||||
|
||||
![]()
S & W? Not familiar with them.
__________________
65 Deuce |